Autoplay
Autocomplete
Previous Lesson
Complete and Continue
Advanced Drone Mapping for Construction and Engineering
Intro to this Section
Welcome to the Course
About Your Instructor (1:00)
Getting Your Advanced Drone Mapping for Construction and Engineering Certificate and Digital Badge (4:33)
Course Textbook
Aerial Mapping Importance in Construction and Engineering
Evolution of Mapping in Construction and Engineering (3:22)
Common Use Cases for Photogrammetry in Construction (6:03)
Team Structures and Roles (3:36)
The Cost of Inaccurate Data (2:52)
Coordinate Systems Used in Construction and Surveying
Why Construction Projects Need Coordinate Systems (1:28)
State Plane Coordinate Systems vs Geographic Coordinate Systems (2:01)
How State Plane Coordinate Systems are Organized (EPSG Codes) (2:14)
Understanding Northings and Eastings (3:31)
Scale Factors (4:11)
Published vs. Local/Calibrated Coordinate Systems (3:35)
Project: Avalon Development
About Our Example Project (2:06)
Deliverables and Calculations for the Project (3:50)
Understanding the Engineering Plan Sets (2:43)
Engineering Plan Set Review for Avalon Development (8:33)
Site Planning and Data Acquisition Strategy
Site Overview, Flight Area, Obstruction (Power Lines/Towers), and GCP Location Review (5:37)
Exporting/Importing KML File for Flight Automation (2:27)
Automated Flight Mission Settings (5:46)
Manually Designing Automated Flight Area (1:19)
Deciding on GCP and Checkshot Placement (3:20)
Gear Selection and Correction Methods (5:36)
Fieldwork
Initial Jobsite Walkthrough (1:44)
Review of GCP and Checkshot Plan (3:04)
Setting Up GCP Targets (3:54)
Shooting and Checking Project Temporary Benchmarks (TBM) (6:07)
Flying Wingtra Mission (4:33)
Data Processing
Software and Geotagging Process We’re Using (1:26)
Geotagging Our Photos (2:00)
Processing Scenarios (0:51)
Explaining Our GNSS Base Selection and Options (2:15)
Looking at Our Project Control File (1:44)
Processing Scenario 1 (5:49)
Processing Scenario 2 (0:28)
Processing Scenario 3 (6:39)
Output Review: Verifying Quality and Accuracy (8:54)
Comparing Data of Processing Scenarios (4:02)
Incorporating and Working with Design Files and 3rd Party Data
Types of Design Files and 3rd Party Data (2:45)
Importing Design Data (2:30)
What to Do When Stuff Doesn’t Line Up (2:56)
Analysis: Getting the Calculations We Need
About this Section (0:19)
Total Project Take Off Calculation (9:37)
Stockpile Cut/Fill Calculations (2:29)
Generating Contours (2:16)
Final Report - Takeoff Calculations, Stockpile Measurements, and Contours (4:02)
Comparing Plan Set Water Run Off to Contour Data (1:56)
Safety Slope Profile Calculation (3:32)
Final Exam
Final Exam
Exporting/Importing KML File for Flight Automation
Lesson content locked
If you're already enrolled,
you'll need to login
.
Enroll in Course to Unlock